Digigram IQOYA X/LINK Series User Manual page 58

IQOYA X/LINK range user manual
Settings for an AES67 stream
Most of the parameters below are automatically filled in after having browsed and
selected an AES67 stream.
Port: UDP port number for receiving the stream
IP address: multicast or unicast IP@
Network interface: network interface (LAN or VLAN) used for receiving the
stream.
IGMPv3 filtering: Allows including or excluding source IP addresses of the
multicast stream.
If Include or Exclude value is selected, the list of IP addresses can be entered via
the following interface:
Jitter: enter the jitter value. This value must be at least equal to the jitter value
reported from the Metrics on the stream.
Payload: Set to 98.
Mode: defines the number of channels to be considered from the stream (Mono or
stereo).
Sample rate: 32 kHz, 44.1 kHz, or 48 kHz
Audio Format: PCM 12, 16, 20 or 24 bits
Settings for a RAVENNA stream
Most of the parameters below are automatically filled in after having browsed and
selected a RAVENNA stream.
Port: UDP port number for receiving the stream
IP address: multicast or unicast IP@
Network interface: network interface (LAN or VLAN) used for receiving the
stream.
IGMPv3 filtering: Allows including or excluding source IP addresses of the
multicast stream.
If Include or Exclude value is selected, the list of IP addresses can be entered via
the following interface:
Jitter: enter the jitter value. This value must be at least equal to the jitter value
reported from the Metrics on the stream.
Payload: Set to 98.
Mode: defines the number of channels to be considered from the stream (Mono or
stereo).
Sample rate: 32 kHz, 44.1 kHz, or 48 kHz
Audio Format: PCM 12, 16, 20 or 24 bits
Settings for a Livewire stream
Livewire channel:
Port: UDP port number for receiving the stream
IP address: multicast or unicast IP@
Network interface: network interface (LAN or VLAN) used for receiving the
stream.
IGMPv3 filtering: Allows including or excluding source IP addresses of the
multicast stream.
If Include or Exclude value is selected, the list of IP addresses can be entered via
the following interface:
Jitter: enter the jitter value. This value must be at least equal to the jitter value
reported from the Metrics on the stream.
Payload: Set to 98.
It is possible to enable or disable the reception of one or several declared AoIP input streams.
58