Table of Contents
Advertisement
Parameter
IP service name
Transport protocol
Encapsulation
Audio stream
IP address
listening port
Jitter
Loss
Synchro clock
In-band format signalling
payload type
URL
Type
Description
Read/Write
Name given to this IP service. This is the name that can be selected in the source of a decoding
priority of an output program.
Read/Write
Values: RTP, UDP, Icecast/Shoutcast
Read/Write
Only displayed if the selected transport protocol is different from Icecast/Shoutcast.
Values are: None, MPEG-TS SPTS or MPEG-TS MPTS.
Read/Write
For RTP and UDP protocols only.
In unicast, set this parameter to 127.0.0.1, otherwise enter the multicast IP address to listen to.
Read/Write
For RTP and UDP protocols, value of the UDP port to listen to.
For Icecast/Shoutcast, value of the TCP port to listen to.
Read/Write
For RTP and UDP protocols only. Enter the input buffering size to compensate for the jitter of the
network. This value, expressed in ms, must be at least equal to the measured jitter.
In case there is FEC, it is necessary to consider the measured jitter for "primary and FEC
stream".
Read/Write
For the RTP protocol only. Defines the duration of consecutive lost packets until which IQOYA
replaces lost frames by silence, without flushing the buffer of jitter.
If the absence of received consecutive packets exceeds this duration, the buffer of jitter is then
flushed, and filled again with received packets; this allows resynchronization on the incoming IP
audio stream, but this generates a silence longer than the consecutive packet lossed.
To avoid long audio silences when only a few consecutive packets are lost (especially for high
jitter values), it is recommended to set the Loss value to approximately 3/4 of the jitter buffer.
Read/Write
For the RTP protocol only. Select NTP in case the audio synchronization on NTP is used for
decoding this stream (optional feature).
Read/Write
For the RTP protocol only.
Set this parameter to "Yes" if it is also set to "Yes" on the IQOYA encoder.
Set this parameter to "No" if it is not configured on the IQOYA encoder, or if the encoder is
another brand.
Read/Write
For the RTP protocol only. Only displayed if "In-band format signalling" is set to "No".
Enter the payload value of the audio stream (same payload value as configured on the stream
encoder).
Read/Write
Only displayed when Transport Protocol is set to Icecast/Shoutcast.
URL of the Icecast/Shoutcast server. Example: streamer.mysite.com.
IQOYA X/LINK range user manual
81
Advertisement
Table of Contents
