Digigram IQOYA X/LINK Series User Manual page 74

Click on "Save" to confirm the settings. Click on "Save & New" to confirm the settings and create a new IP service with the
same parameters.
Click on "Close" to discard the settings
Encapsulation = None and Transport protocol = HLS
Note: Since version 3.12, it is possible to enable the descriptor
"ES_Rate_flag'' in the PES. See appendix H.
Parameter Type
Program: Basic settings
Program 1(reference) Read/Write
Program: Advanced settings
Delay on Program x Read/Write
Audio stream: Basic settings
CDN Preset Read/Write
Server URL Read/Write
Description
Select the Program to be streamed from the list of Programs. Program can be in MPEG Layer 2, MPEG
Layer 3, and AAC-ADTS formats.
For multi bitrate HLS, up to 5 additional audio Programs can be selected. They all must be the same audio
compression format (but of course with different bitrates). Click on the icon
Delay (expressed in audio samples) to be applied to the Program number X.
This can be used to adjust the synchronization between Programs..
Select the preset that corresponds to the CDN you want to use; this will only display the parameters
required by this CDN. Presets are:
- AWS: for Amazon Web Services (with AWS authentication)
- Akamai (MSL4): for Akamai CDN (with digest authentication)
Select "None" to access other CDN's.
Address of the origin server to connect to.
IQOYA X/LINK range user manual
"Maximum_Bitrate_Descriptor" in the PMT, and the flag
to add a Program.
74