Table of Contents
Advertisement
To modify the parameters of a COM port, click on its
Parameter
Device name
Data transmission mode
Baud rate
Data bits
Stop bits
Parity
Status
Click on "Save" to confirm the changes.
8.1.1.4.2 Preferences −> Auxiliary data −> GPIO
X/LINK offers the possibility to use physical GPIOs, or virtual GPIOs through UDP ports. The status of the physical or virtual
GPI's is tunneled in-band so that the decoder can output the status information on physical or virtual GPO's.
Virtual GPIO allow third party applications to send/receive status information via IP to/from IQOYA.32 virtual GPI status can
be tunneled.
Structure of a virtual status information frame over UDP
Type
Read
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
IQOYA X/LINK range user manual
icon on the left column.
Description
Name of the RS232 port
Defines the way serial data are inserted into the IP audio stream.
Generic: serial data are inserted as they arrive.
UECP: serial data are inserted each time a complete RDS UECP frame is fully
received from the RS232 port.
Serial port baud rate in bits/s, from 1200 bps to 40 Kbits/s
Select the number of bits for each character (6, 7 or 7)
Enter the number of bits used to signal the end of a character: 1 or 2.
Select the method used for detecting errors on the RS232 port transmission:
●
None: No
●
Odd: number of bits of each character (including the parity bit) is always odd.
●
Even: number of bits of each character (including the parity bit) is always even.
Enable: the COM port is enabled.
Disable: the COM port is disabled.
51
Advertisement
Table of Contents
