Table of Contents
Advertisement
–
"Two 8 x SAS/SATA backplanes" on page 307
–
"Two 8 x AnyBay backplanes (Gen 4)" on page 311
–
"Two 8 x NVMe backplanes (Gen 4)" on page 315
–
"One 8 x SAS/SATA and one 8 x AnyBay (Gen 4) backplanes" on page 317
–
"One 8 x SAS/SATA and one 8 x NVMe (Gen 4) backplanes" on page 323
–
"One 8 x AnyBay and one 8 x NVMe backplanes (Gen 4)" on page 329
• Three front backplanes:
–
"Three 8 x SAS/SATA backplanes" on page 333
–
"Three 8 x AnyBay backplanes" on page 382
–
"Three 8 x NVMe backplanes (Gen 4)" on page 384
–
"One 8 x AnyBay and two 8 x NVMe backplanes (Gen 4)" on page 387
–
"One 8 x SAS/SATA and two 8 x NVMe (Gen 4) backplanes" on page 389
–
"Two 8 x SAS/SATA and one 8 x AnyBay (Gen 4) backplanes" on page 392
–
"Two 8 x SAS/SATA and one 8 x NVMe (Gen 4) backplanes" on page 408
–
"24 x 2.5" SAS/SATA expander backplane" on page 411
One 8 x SAS/SATA backplane
This section provides cable routing information for the server model with one 8 x 2.5-inch SAS/SATA front
drive backplane.
To connect power cables for the front backplane(s), refer to
drive bays" on page
297.
To connect signal cables for the front backplane(s), refer to the following cable routing scenarios depending
on your server configuration.
•
"Onboard connectors" on page 299
•
"8i/16i RAID/HBA adapter" on page 300
•
"CFF 8i/16i RAID/HBA adapter" on page 301
Onboard connectors
The following shows the cable connections for the 8 x 2.5-inch SAS/SATA configuration with onboard
connectors.
Connections between connectors:
↔
↔
↔
,
,
, ...
1
1
2
2
3
3
"Backplanes: server models with 2.5-inch front
↔
n
n
Chapter 6
.
Internal cable routing
299
Advertisement
Table of Contents
