Table of Contents
Advertisement
Figure 151. Installing a T-shape performance PHM
a.
Rotate the anti-tilt wire bails inward.
b.
Align the triangular mark and four Torx T30 nuts on the PHM with the triangular mark and
threaded posts of the processor socket; then, insert the PHM into the processor socket.
c.
Rotate the anti-tilt wire bails outward until they engage with the hooks in the socket.
d.
Fully tighten the Torx T30 nuts in the installation sequence shown on the heat-sink label.
Tighten the screws until they stop; then, visually inspect to make sure that there is no gap
between the screw shoulder beneath the heat sink and the processor socket. (For reference,
the torque required for the fasteners to fully tighten is 0.9-1.3 newton-meters, 8-12 inch-
pounds).
After you finish
1. Complete the parts replacement. See
PSU air baffle replacement
Use this information to remove and install a power-supply-unit (PSU) air baffle.
•
"Remove a PSU air baffle" on page 189
•
"Install a PSU air baffle" on page 191
Remove a PSU air baffle
Use this information to remove a PSU air baffle.
About this task
"Complete the parts replacement" on page
Chapter 5
269.
.
Hardware replacement procedures
189
Advertisement
Table of Contents
