Table of Contents
Advertisement
Figure 192. 7mm SSD riser cage installation
Step 4.
Connect the cables from the backplanes to the system board assembly. See
cable routing" on page
After you finish
1. Reinstall all the drives and fillers (if any) into the drive bays. See
2. Complete the parts replacement. See
Rear drive backplane and drive cage replacement
Use this information to remove and install rear drive backplanes and drive cages.
•
"Remove the 4 x 2.5" drive backplane and drive cage" on page 221
•
"Install the 4 x 2.5" drive backplane and drive cage" on page 223
•
"Remove the 8 x 2.5" drive backplane and drive cage" on page 225
•
"Install the 8 x 2.5" drive backplane and drive cage" on page 226
•
"Remove the 2 x 3.5" drive backplane and drive cage" on page 228
•
"Install the 2 x 3.5" drive backplane and drive cage" on page 230
•
"Remove the 4 x 3.5" drive backplane and drive cage" on page 232
•
"Install the 4 x 3.5" drive backplane and drive cage" on page 234
Remove the 4 x 2.5" drive backplane and drive cage
Use this information to remove the rear 2.5-inch 4-bay drive backplane and drive cage.
About this task
Attention:
• Read
"Installation Guidelines" on page 55
work safely.
271.
"Complete the parts replacement" on page
and
"Safety inspection checklist" on page 56
Chapter 6 "Internal
"Install a hot-swap drive" on page
269.
.
Chapter 5
Hardware replacement procedures
83.
to ensure that you
221
Advertisement
Table of Contents
