Table of Contents
Advertisement
NVMe cable routing to onboard PCIe connectors
Figure 288. Cable routing when two processors installed
From
Backplane 1: NVMe 0-1
1
Backplane 1: NVMe 2-3
2
Backplane 1: NVMe 4-5,
3
6-7
Two 8 x SAS/SATA backplanes
This section provides cable routing information for the server model with two 8 x 2.5-inch SAS/SATA front
drive backplanes.
To connect power cables for the front backplane(s), refer to
drive bays" on page
297.
To connect signal cables for the front backplane(s), refer to the following cable routing scenarios depending
on your server configuration.
•
"16 x SAS/SATA" on page 308
–
"Onboard connectors + 8i RAID/HBA adapter" on page 308
–
"8i/16i RAID/HBA adapter" on page 309
–
"CFF 16i RAID/HBA adapter" on page 310
•
"14 x SAS/SATA" on page 310
To
Onboard: PCIe 8
Onboard: PCIe 7
Onboard: PCIe 6, 5
Figure 289. Cable routing when one processor installed
From
Backplane 1: NVMe 0-1,
1
2-3
Backplane 1: NVMe 4-5
2
Backplane 1: NVMe 6-7
3
"Backplanes: server models with 2.5-inch front
Chapter 6
To
Onboard: PCIe 3, 4
Onboard: PCIe 2
Onboard: PCIe 1
.
Internal cable routing
307
Advertisement
Table of Contents
