Table of Contents
Advertisement
Remove the front I/O module
Use this information to remove the front I/O module.
About this task
Depending on the server model, the server might come with one of the following front operator panels:
Front operator panel without an LCD display
1
Attention:
• Read
"Installation Guidelines" on page 55
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
BmyijyY0-lNvapM4fTV5Gf
Procedure
Step 1.
Make preparation for the task.
a.
If the security bezel is installed, remove it. See
b.
If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
c.
Remove the top cover. See
d.
Remove the air baffle. See
Step 2.
Disconnect the cables of the front I/O module from the system board assembly.
Notes:
ThinkSystem SR650 V3 User Guide
104
and
"Safety inspection checklist" on page 56
73.
.
"Remove the top cover" on page
"Remove the air baffle" on page
Front operator panel with an LCD display (called
1
integrated diagnostics panel)
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
"Remove the security bezel" on page
"Remove the server from rack" on page
266.
85.
to ensure that you
237.
73.
Advertisement
Table of Contents
