Figure 118. Riser cage tray removal
a.
Remove the screws that secure the riser cage tray.
b.
Slide the riser cage tray backwards and then lift it out the chassis.
After you finish
1. Remove the PCIe adapter from the riser assembly. See
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Remove a PCIe adapter
Use this information to remove a PCIe adapter. The PCIe adapter can be an Ethernet card, a host bus
adapter, a RAID adapter, an add-in PCIe SSD adapter, or any other supported PCIe adapters.
About this task
Attention:
• Read
"Installation Guidelines" on page 55
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board assembly), drive backplanes or drive cables, back up all important data that is stored
on drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Watch the procedure
and
"Safety inspection checklist" on page 56
73.
"Remove a PCIe adapter" on page
.
Chapter 5
Hardware replacement procedures
159.
to ensure that you
159