Table of Contents
Advertisement
After you finish
1. Install any components that you have removed:
a.
"Install a riser assembly" on page 166
b.
"Install the 7mm drive cage" on page 219
c.
"Rear drive backplane and drive cage replacement" on page 221
d.
"Install the top cover" on page 268
2. Complete the parts replacement. See
Middle drive cage and drive backplane replacement
Use this information to remove and install the middle drive cages and drive backplanes.
Depending on the server configurations, the server supports one of the following middle drive cages. For
detailed information, see
Drive cage type
Middle 2.5-inch 8-bay drive cage
Middle 3.5-inch 4-bay drive cage
•
"Remove the middle drive cage and drive backplanes" on page 144
"Complete the parts replacement" on page
"Technical rules" on page
59.
Backplane type
• Two 2.5-inch SAS/SATA 4-bay backplanes
• Two 2.5-inch NVMe 4-bay backplanes
One 3.5-inch SAS/SATA 4-bay backplane
.
Chapter 5
Hardware replacement procedures
269.
143
Advertisement
Table of Contents
