Figure 170. RAID flash power module installation (on the air baffle)
a.
Open the retention clip on the holder.
b.
Put a RAID flash power module into the holder.
c.
Press it down to secure it into the holder.
Step 3.
Connect the RAID flash power module to an adapter with the extension cable that comes with the
RAID flash power module. See
After you finish
Complete the parts replacement. See
Remove a RAID flash power module from the middle 2.5-inch drive cage
Use this information to remove a RAID flash power module (also called supercap) from the middle 2.5-inch
drive cage.
About this task
Attention:
• Read
"Installation Guidelines" on page 55
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Watch the procedure
A video of this procedure is available at YouTube:
BmyijyY0-lNvapM4fTV5Gf
Procedure
Step 1.
Make preparation for the task.
a.
If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b.
Remove the top cover. See
ThinkSystem SR650 V3 User Guide
204
Chapter 6 "Internal cable routing" on page
"Complete the parts replacement" on page
and
"Safety inspection checklist" on page 56
73.
.
"Remove the top cover" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
"Remove the server from rack" on page
266.
271.
269.
to ensure that you
73.