Table of Contents
Advertisement
Figure 173. Removing the RAID flash power module
a.
Pull out the blue latch on the supercap cover.
b.
Slide the cover out of the holder.
c.
Take the RAID flash power module out of the holder.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a RAID flash power module on the middle drive cage
Use this information to install a RAID flash power module (also called supercap) on the middle 2.5-inch drive
cage.
About this task
Attention:
• Read
"Installation Guidelines" on page 55
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
BmyijyY0-lNvapM4fTV5Gf
Procedure
Step 1.
Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2.
Install the RAID flash power module.
ThinkSystem SR650 V3 User Guide
206
and
"Safety inspection checklist" on page 56
73.
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
to ensure that you
Advertisement
Table of Contents
