Table of Contents
Advertisement
b.
Slide the drive cage towards the rear of the chassis to release it.
Step 3.
Remove the middle drive backplane.
Figure 194. Removing the rear 4 x 2.5-inch drive backplane
a.
Open the release latches in the direction as shown.
b.
Rotate the backplane from the top to disengage it from the pins on the drive cage.
c.
Carefully lift the backplane out of the drive cage.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the 4 x 2.5" drive backplane and drive cage
Use this information to install 2.5-inch 4-bay drive backplane and drive cage.
About this task
Attention:
• Read
"Installation Guidelines" on page 55
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• The rear drive cage is supported on some server models with thermal requirements. See
on page 69
to ensure that the server is under permitted ambient temperature and the correct heat sink
and system fans are used. If needed, replace your heat sink or system fan first.
–
"Processor and heat sink replacement (trained technician only)" on page 176
–
"System fan replacement" on page 254
Watch the procedure
A video of this procedure is available at YouTube:
BmyijyY0-lNvapM4fTV5Gf
and
"Safety inspection checklist" on page 56
73.
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 5
Hardware replacement procedures
to ensure that you
"Thermal rules"
223
Advertisement
Table of Contents
