Table of Contents
Advertisement
LED
System ID LED (blue)
1
System error LED (yellow)
2
XCC system management port LEDs
This topic provides information on LEDs of XCC system management port.
The following table describes the problems that are indicated by LEDs on XCC system management port.
Figure 476. XCC system management port LEDs
LED
Description
Ethernet port
Use this green LED to distinguish the network connectivity status:
1
link LED
• Off: The network link is disconnected.
• Green: The network link is established.
Ethernet port
Use this green LED to distinguish the network activity status:
2
activity LED
• Off: The server is disconnected from a LAN.
• Green: The network is connected and active.
Power supply LEDs
This topic provides information about various power supply LED status and corresponding action
suggestions.
The following minimal configuration is required for the server to start:
• One processor in socket 1
• One DIMM in slot 7
• One power supply
• One HDD/SSD drive, one M.2 drive, or one 7mm drive (if OS is needed for debugging)
• Five system fans
The following table describes the problems that are indicated by various combinations of the power-supply
LEDs and the power-on LED and suggested actions to correct the detected problems.
Description
This LED helps you to visually locate
the server.
LED on: an error has occurred.
Action
A system ID button with LED is also
located on the front of the server. You
can press the system ID button to
turn on/off or blink the front and rear
ID LEDs.
Check system logs or internal error
LEDs to identify the failed part. For
more information, see
"System error
LED" on page
.
.
Chapter 8
Problem determination
469
Advertisement
Table of Contents
