Figure 276. Riser card 3/4 signal cable routing
From
Swift connector 1 on riser card 3
1
Swift connector 2 on riser card 3
2
Swift connector 1 on riser card 4
3
Swift connector 2 on riser card 4
4
Backplanes: server models with 2.5-inch front drive bays
This section provides backplane cable connection information for server models with 2.5-inch front drive
bays.
Before you start
Ensure below parts are removed before starting cable routing for front backplanes.
• Top cover (see
"Remove the top cover" on page
• Air baffle (see
"Remove the air baffle" on page
• Fan cage (see
"Remove the system fan cage" on page
Power cable connections
The server supports the following 2.5-inch drive backplanes:
To
PCIe 1 connector on the system board assembly
PCIe 2 connector on the system board assembly
PCIe 9 connector on the system board assembly
PCIe 10 connector on the system board assembly
266)
85)
259)
.
Chapter 6
Internal cable routing
297