Table of Contents
Advertisement
Figure 358. Middle backplane cable routing
From
1
• Backplane 5: SAS
• Backplane 6: SAS
2
• Backplane 5: PWR
• Backplane 6: PWR
Front + middle + rear backplanes: 24 x 2.5" SAS/SATA + 8 x 2.5" SAS/SATA+ 4 x 2.5"/
8 x 2.5" SAS/SATA
This topic provides cable routing information for the 12 x 3.5-inch SAS/SATA front backplane, two 4 x 2.5-
inch SAS/SATA middle backplanes, and one 4 x 2.5-inch/8 x 2.5-inch SAS/SATA rear backplane.
To connect power cables for the front backplane(s), refer to
drive bays" on page
297.
To connect signal cables for the front backplane(s), refer to the following cable routing scenarios depending
on your server configuration.
•
"24 x 2.5" SAS/SATA + 8 x 2.5" SAS/SATA+ 4 x 2.5" SAS/SATA" on page 366
•
"24 x 2.5" SAS/SATA + 8 x 2.5" SAS/SATA+ 8 x 2.5" SAS/SATA" on page 375
To
16i adapter
• Gen 4: C1
• Gen 3: C2C3
• Onboard: backplane power
• Onboard: backplane sideband
• Riser 1: PWR
"Backplanes: server models with 2.5-inch front
Chapter 6
.
Internal cable routing
365
Advertisement
Table of Contents
