Table of Contents
Advertisement
Figure 139. PHM components
Heat sink
1
Heat sink triangular mark
2
Processor identification label
3
Nut and wire bail retainer
4
Torx T30 nut
5
Anti-tilt wire bail
6
Processor carrier
7
Clips to secure carrier to heat sink
8
Watch the procedure
A video of this procedure is available at YouTube:
BmyijyY0-lNvapM4fTV5Gf
Procedure
Step 1.
Make preparations for this task.
a.
If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b.
Remove the top cover. See
ThinkSystem SR650 V3 User Guide
178
.
"Remove the top cover" on page
Clips to secure processor in carrier
9
Carrier triangular mark
10
Processor ejector handle
11
Processor heat spreader
12
Thermal grease
13
Processor contacts
14
Processor triangular mark
15
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
"Remove the server from rack" on page
266.
73.
Advertisement
Table of Contents
