Raid Flash Power Module Replacement; Air Baffle; Baffle - Lenovo ThinkSystem SR665 V3 User Manual

Figure 87. Installing the cable retainer
Step 5. Connect the cables to the system board assembly. See
167.
After you finish
1. Install the air baffle. See
2. Install the security bezel if you have removed it. See
3. Complete the parts replacement. See

RAID flash power module replacement

The RAID flash power module protects the cache memory on the installed RAID adapter. Follow instructions
in this section to remove and install a RAID flash power module (also called supercap).
Remove a RAID flash power module from the air baffle
Follow instructions in this section to remove a RAID flash power module (also called supercap) from the air

baffle.

About this task
Attention:
• Read "Installation Guidelines" on page 39
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
"Install the air baffle" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 40
48.
Chapter 6 "Internal cable routing" on page
59.
"Install the security bezel" on page
.
Chapter 5 Hardware replacement procedures
138.
164.
to ensure that you
127