Remove The Raid Flash Power Module On The Riser - Lenovo ThinkSystem SR630 V3 User Manual

After you finish
1. Install the air baffle on the chassis. See
2. Connect the flash power module to an adapter with the extension cable that comes with the flash power
module. See "RAID flash power modules" on page
3. Complete the parts replacement. See

Remove the RAID flash power module on the riser

Use this information to remove the RAID flash power module on the riser.
About this task
Attention:
• Read "Installation Guidelines" on page 51
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Watch the procedure
A video of this procedure is available on YouTube:
CfNsWy-689CRZHExrZEi9I
Procedure
Step 1. Remove the top cover. See
Step 2. Disconnect the cable of the RAID flash power module.
Step 3. Remove the riser assembly. See
ThinkSystem SR630 V3 User Guide
196
"Install the air baffle" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 52
68.
.
"Remove the top cover" on page
"Remove a riser card" on page
78.
264.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
243.
208.
246.
to ensure that you