Dss/Blf Appearances - Panasonic VB-44210G User Manual

Section 700 - Operation

DSS/BLF Appearances

(CPC-AII and CPC-B Version 2.0 or higher)
Description
When a DSS/BLF key is programmed, it automatically provides direct station
selection and busy lamp field for the assigned extension number. If desired,
the DSS/BLF key can also provide ring monitor.
For example, you can set extension A as a DSS/BLF key on extension B.
When extension A rings, the LED of the DSS/BLF key on extension B
flashes. If extension B answers the call by pressing the DSS/BLF key, the
LED on extension A goes off and the call remains only on the DSS/BLF key
of extension B.
Ringing can be set on either one or both extensions. If the extensions are not
set for ringing, the LED of the DSS/BLF key will flash red. If the extensions
are set for ringing, the LED will flash green.
When extension A is in use, the LED of the DSS/BLF key on extension B will
light red. If one extension has the Absence Message, Call Forwarding, or Do-
Not-Disturb feature activated, the DSS/BLF key will light green.
Operation
To assign a DSS/BLF key:
1. Press the PROG key.
2. Press the FF key you want to assign the DSS/BLF appearance to.
3. Dial the extension number.
4. Press the HOLD key.
To make an intercom call using the DSS/BLF key:
Press the idle DSS/BLF key.
To pick up a call on a DSS/BLF key:
Press the flashing DSS/BLF key.
DBS-2.3/9.2-700 DBS Manual - Revised April 2000
Chapter 4. Key Telephone Features
4-61