Appendix D: Cpc-Aii/B 9.1 Updates; Call Record - Panasonic VB-44210G User Manual

Appendix D: CPC-AII/B 9.1 Updates

CPC-AII/B Version 9.1 adds support for the "Call Record" feature available with
PanaVOICE™ Voice Mail systems. In addition, several quality improvements are
incorporated in Version 9.1.
CAUTION:
illegal to record telephone communications without the consent of all
parties. In other states, it is illegal to record without the consent of one
party. These laws do not make the Call Record feature on a telephone
system illegal. Before activating this feature, please check applicable
state and federal laws.

Call Record

Requires PanaVOICE equipped with Software Version 2.1 (Q32136) or later.
Description
Programming
Operation
DBS-2.3/9.2-700
When using the "Call Record" feature in some states it is
The call record feature allows a user to record a trunk conversation at the
press of preassigned Call Record FF key. The conversation is saved to the
user's voice mail box.
See Section 400 - Programming (Appendix F) for more detailed
programming information.
To record a trunk call:
To record a trunk call, press the Call Record key. The LED flashes
while the connection to the Voice Mail recording port is being
established. This may take a few seconds. When recording begins, the
LED lights solid, "Recording" appears on the display, and the audio
message "Recording" is heard by both parties.
If call record cannot be established (no voice mail port available, no
conference circuit available, etc.), the LED extinguishes and a double
splash tone sounds.
Recording continues until you hang up, you press the Call Record key
again or PanaVOICE stops recording due to a PanaVOICE time-out,
lack of disk space, etc.
In the event PanaVOICE stops recording during a conversation, a beep
tone is issued, the LED extinguishes and "Recording" disappears from
the display.
If the outside party hangs up first, you may continue recording call
follow-up information.
DBS Manual - Revised April 2000 Page D-1