Panasonic VB-44210G User Manual page 39

Section 700 - Operation
answer before pressing the DSS/BLF key. The One-Touch VM Access works
with virtually every voice mail systems.
Note: The VM key is assigned differently, depending on whether it is used
for personal message retrieval or attendant transfer. See the following
"Operation" section for instructions.
Operation
To assign a voice mail key:
Note: You cannot program this feature if trunks are assigned to the key. First
clear the FF assignments, then use the following procedures to assign the VM
key.
1. Press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key, DSS key, or One-Touch key.
4. Press the CONF key.
5. Press the AUTO key.
6. Dial the voice mail extension number.
7. If the key is for personal message retrieval, enter a password (XXX or
8. Press the HOLD key.
Attendant Transfer to Voice Mail
1. Answer an incoming call.
DBS-2.3/9.2-700
• The phone issues intercom dial tone.
• The ON/OFF LED lights.
AUTO followed by a speed dial number) if desired. If the key is for
attendant transfer to voice mail, do not enter a password but include any
special codes (* or #, for example) if they are required by the voice mail
system.
Note: The length of the password and the VM extension number cannot
exceed six digits. If the VM number and the password total more than six
digits, assign the password to a personal or system speed dial number (00-
99, 000-199 or 900-909). If you are accessing the Panasonic Voice Mail,
it is best to include a # sign at the end of the password.
DBS Manual - Revised April 2000
Chapter 2. Attendant Features
2-19