Panasonic VB-44210G User Manual page 89

Section 700 - Operation
4. From your terminal communications program, type the following
5. After the DBS responds, type P and then press Enter.
Terminal Programming Through DISA
Note: The DBS must be equipped with an MFR card and a RAI card to allow
terminal programming using this method.
When programming through a DISA trunk, perform the following steps:
1. Dial into the DBS through a DISA trunk.
2. Once you are connected, type #69999 from your terminal communications
3. After the DBS responds with REMT>, type P and then press Enter.
Terminal Programming Through a CO Trunk and Operator Transfer
Note: The DBS must be equipped with an MFR card and a RAI card to allow
terminal programming using this method.
When programming through a normal trunk, perform the following steps:
1. Dial into the DBS through a normal trunk.
2. Ask the operator to place you on hold and dial #69999 to transfer you into
3. After the DBS responds with REMT>, type P and then press Enter.
DBS-2.3/9.2-700
command:
#99xxxx (where xxxx = the site's password)
Follow the directions on the screen to access the desired program. (See
"Terminal Programming Commands.")
program.
Follow the directions on the screen to access the desired program. (See
"Terminal Programming Commands.")
remote programming.
Follow the directions on the screen to access the desired program. (See
"Terminal Programming Commands.")
DBS Manual - Revised April 2000
Chapter 3. System Features
Page 3-43