Konica Minolta bizhub C658 Service Manual page 1317

bizhub C658/C558/C458/C368/C308/C258
3. USB memory
3.1 Preparation
3.1.1 System preparation
• PC with USB ports
• USB memory
• USB flash memory compatible with the USB (1.1/2.0/3.0) interface. The speed is limited to USB2.0 specifications even if using a
device that supports USB3.0.
• The USB memory is formatted in FAT32 format.
• No security functions such as encryption and password lock have been added (or the USB memory allows its security functions to be
turned OFF).
• A USB memory that is recognized by the computer as two or more drives cannot be used.
• We recommend that you use a memory device with no more than 32 GB of capacity.
NOTE
▪ Possible to be non-operational products.
3.1.2 USB memory used to update firmware
1. Uncompress the firmware file.
2. Connect a USB memory to a PC.
3. Copy the rewriting data folder contained in the extracted data to the root directory of the USB memory.
Product name
bizhub C368/C308/C258
bizhub C658/C558/C458
NOTE
▪ More than one firmware data with a single model can be stored in the USB memory.
▪ In this case, copy the firmware data to the USB memory according to the following procedures.
1. Make the folder named "FWSelect" (case-sensitive) to the root directory of the USB memory.
2. Make a folder with any folder name (one byte alphameric characters, maximum 40 characters) in "FWSelect" folder, and store
the firmware data to the folder.
3.1.3 Directory configuration of USB memory
[1]
[2]
FW****
[3]
FWSelect
[1] USB memory
[3] Storage folder for a plurality of data (Folder name: FW
select (Fixed)) *2
[5] Storage folder for firmware data C (Folder name:
Arbitrary) *2
• *1: Required to start the firmware update screen
• *2: Required only when a plurality of data is stored
3.2 Procedure
1. Turn OFF the main power switch.
2. Connect the USB memory containing the firmware into the USB port on the right side of the control panel.
NOTE
▪ USB memory must be connected with the main power switch off.
Firmware Data Ver.A
Firmware Data Ver.B
[4]
Folder1
Firmware Data Ver.C
[5]
Folder2
Firmware Data Ver.D
[6]
Folder3
J REWRITING OF FIRMWARE > 3. USB memory
Rewriting data folder name
FW0002
FW0005
[2] Rewriting data folder (Required) *1
[4] Storage folder for firmware data B (Folder name:
Arbitrary) *2
[6] Storage folder for firmware data D (Folder name:
Arbitrary) *2
J-3