Drive Belt; Belt Removal (Ebs); Belt Removal (Non-Ebs) - Polaris RZR 900 2017 Service Manual

PVT SYSTEM

DRIVE BELT

BELT REMOVAL (EBS)

NOTICE
Inspect the entire clutch outlet duct (including the outlet
duct screen) when replacing a drive belt. Remove any
debris found in the outlet duct or outlet duct screen
1. Remove the grease fitting on the left rear upper
control arm.
2. Remove the eight screws that retain the outer clutch
cover.
3. Maneuver the outer clutch cover outward as shown
below to access the drive belt.
NOTICE
Removal of left rear wheel or left rear shock is NOT
necessary for belt replacement.
4. Mark the drive belt direction of rotation so that it can
be installed in the same direction.
6.10
5. Insert clutch spreader tool (2877408)
driven clutch as shown (tool included with vehicle's
tool kit).
q
.
Make sure the tool is square with the moveable sheave
surface of the driven clutch.
6. Rotate tool towards the clutch to open the sheaves.
7. Walk the belt out of the driven clutch and drive clutch.
Remove the belt from the vehicle.

BELT REMOVAL (NON-EBS)

Inspect the entire clutch outlet duct (including the outlet
duct screen) when replacing a drive belt. Remove any
debris found in the outlet duct or outlet duct screen
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
w
into the
NOTICE
NOTICE
© Copyright Polaris Industries Inc.
q
.