Brake Burnishing Procedure - Polaris RZR 900 2017 Service Manual

Hide thumbs Also See for RZR 900 2017:

Table of Contents

5. Install the adjustment set screw and turn clockwise

until the stationary pad contacts the disc, then back

off 1/2 turn.

6. Verify fluid level in reservoir is up to the MAX line

inside reservoir and install reservoir cap.

Master Cylinder Fluid:

Up to MAX line inside reservoir

7. Install wheel and torque wheel nuts to specification.

Aluminum: 120 ft-lbs (163 Nm)

Steel: 60 ft-lb (81 Nm)

9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual

BRAKE BURNISHING PROCEDURE

It is required that a burnishing procedure be performed

after installation of new brake pads to extend service life

and reduce noise.

Start machine and slowly increase speed to 30 mph.

Gradually apply brakes to stop machine. Allow pads and

disc to cool sufficiently during the procedure. Do not

allow pads or disc to become hot or warping may result.

Repeat this procedure 10 times. Do not make more

than 3 stops per 1 mile (1.6 km).

BRAKE SYSTEM

Table of Contents