Front Half Shaft Installation - Polaris RZR 900 2017 Service Manual

FRONT HALF SHAFT INSTALLATION

q
1. Install new spring ring on drive shaft. Apply an
anti-seize compound to the splines
2. Align splines of drive shaft with front gearcase and
reinstall the drive shaft. Use a rubber mallet to tap on
the outboard end of the drive shaft if necessary
3. Install drive shaft into the front bearing carrier.
4. Install the upper and lower ball joint ends into the
front bearing carrier.
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
© Copyright Polaris Industries Inc.
5. Install new pinch bolts
specification.
w
.
6. Apply Anti-Seize to drive shaft axle splines.
7. Install front wheel hub assembly
and hand tighten the castle nut. Install washers with
domed side out.
FINAL DRIVE
e
and nuts. Torque to
TORQUE
Ball Joint Pinch Bolts:
42 ft-lb (57 Nm)
r
, cone washers
t
,
8
8.11