Polaris RZR 900 2017 Service Manual page 197

5. Using a dial bore gauge, measure big end I.D. in two
directions shown. Remove bearings when taking
q
measurements . Record measurements and
compare to specifications.
6. Refer to the number printed onto the side of the
connecting rod, between the small and large bore
ends. This number represents the bore diameter.
7. The table below lists the big end bore diameter
specifications.
CONNECTING ROD BIG END BORE DIAMETERS
1
1.7318- 1.7321-
1.7321" 1.7323"
(43.989- (43.996-
43.996 mm) 44.003 mm)
8. Whether using new connecting rods or re-installing
the original ones, refer to the bearing selection chart
provided in the "Connecting Rod Bearing Selection"
procedure in this chapter.
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
© Copyright Polaris Industries Inc.
2 3
1.7323-
1.7326"
(44.003-
44.010 mm)
ENGINE / COOLING SYSTEM
3
3.63