Table of Contents
Advertisement
Remove the PTX10004 Router
IN THIS SECTION
Power Off a PTX10004 | 226
Remove a PTX10004 from a Four-Post Rack Using a Mechanical Lift | 233
Manually Remove a PTX10004 from a Four-Post Rack | 235
To power off and remove a PTX10004 router, read the following sections.
Power Off a PTX10004
Before you power off a PTX10004 router.
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage.
See
"Prevention of Electrostatic Discharge Damage" on page
Ensure that you don't need to forward traffic through the router.
Ensure that you have the following parts and tools available to power off the router:
An ESD grounding strap
An external management device such as a PC
An RJ-45 to DB-9 rollover cable to connect the external management device to the console port on
one of the Routing and Control Boards (RCBs)
To power off a PTX10004 router:
1. Connect to the router using one of the following methods:
Connect a management device to the console (CON) port on an RCB by following the instructions
in
"Connect a PTX10004 Router to a Management Console" on page
Connect a management device to one of the two management (MGMT) ports on the RCB by following
the instructions in
page
152.
2. Shut down Junos OS from the external management device by using the request node power-offnode
operational mode CLI command followed by the request chassis cb slot 0|1. These commands shut
"Connect a PTX10004 Router to a Network for Out-of-Band Management" on
298.
153.
226
Advertisement
Table of Contents
