Table of Contents
Advertisement
Figure 116: Install a QSFP+, QSFP28, or QSFP56-DD Transceiver
PTX10004 Transceiver Removal
Before you begin to remove a transceiver from the PTX10004 line card or RCB, ensure that you have
taken the necessary precautions for safe handling of lasers (see
Warnings" on page
283).
Ensure that you have the following parts and tools available:
Antistatic bag or an antistatic mat
Rubber safety caps to cover the transceiver and fiber-optic cable connector
Dust cover to cover the port
To remove a transceiver from the PTX10004 line card or RCB:
1. Place the antistatic bag or antistatic mat on a flat, stable surface.
2. Wrap and fasten one end of the ESD wrist strap around your bare wrist, and connect the other end of
the strap to the ESD point on the switch.
3. Label the cable connected to the transceiver so that you can reconnect it correctly.
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
Do not look directly into a fiber-optic transceiver or into the ends of
"Laser and LED Safety Guidelines and
221
Advertisement
Table of Contents
