Jnp10K-Pwr-Dc2 Power Specifications - Juniper PTX10004 Hardware Manual

Figure 40: Right-Angle, Bare Cable with Anderson Connector
1 Black wire –"+" or "-" for HVDC and "Hot or neutral"
—
for AC
2 Green wire - Ground
—

JNP10K-PWR-DC2 Power Specifications

Table 39 on page 102 lists the power specifications for the high-voltage direct current (HVDC) power supply
used in PTX10004 routers.
Table 39: Power Specifications for the JNP10K-PWR-DC2 Power Supply
Item
DC input voltage
DC input current rating
Output power
1
3
3 White wire – "+" or "-" for HVDC and "Hot or neutral"
—
for AC
Specifications
Minimum operating voltage: –40 VDC
Nominal operating voltage: –48 VDC
Operating voltage range: –40 VDC through –72 VDC
76-A maximum at minimum operating voltage (-40 VDC) with 80-A
DIP switch setting and 5500-W output load
64-A maximum at nominal operating voltage (–48 VDC) with 80-A
DIP switch setting and 5500-W output load
60-A maximum at minimum operating voltage (-40 VDC) with 60-A
DIP switch setting and 4400-W output load
50-A maximum at nominal operating voltage (-48 VDC) with 60-A
DIP switch setting and 4400-W output load
2200 W for low-input (60-A) single feed
4400 W for low-input (60-A) dual feed
2750 W for high-input (80-A) single feed
5500 W for high-input (80-A) dual feed
2
102