Table 20: Routing and Control Board Status LEDs
LED
PWR (Power)
STS (Status)
MST (Primary)
PTX10004 Management Port LEDs
The two management ports on the RCB of a PTX10004 have LEDs that indicate link status and link activity.
These two ports, located on the RCB panel between the clocking connections and the USB port, are both
labeled MGMT. The left management port (RJ-45) is for 10/100/1000 BASE-T connections, and the right
port (SFP) is for 10/100/1000 BASE-T and small form-factor pluggable (SFP) 1000 BASE-X connections
(see
Figure 27 on page
66). The copper (RJ-45) port has separate LEDs for status and activity. The fiber
(SFP) port has a combination link and activity LED.
Figure 27: Management Port LEDs on a PTX10004
1
Status (RJ-45)
—
2
Activity (RJ-45)
—
Color
State
Green
On steadily
Yellow
Blinking
None
Unlit
Green
On steadily
Green
Blinking
Yellow
On steadily
Yellow
Blinking
None
Unlit
Green
On steadily
None
Unlit
Description
The RCB is receiving adequate power.
The RCB has detected an error.
The RCB is not powered up.
The RCB is online and functioning correctly.
The beacon feature is enabled.
The RCB is booting.
The RCB has detected an error.
The RCB is not receiving power.
The RCB is the primary RCB.
The RCB is the backup RCB.
3
Link/activity/status (SFP)
—
66