Table of Contents
Advertisement
To insert a line card into an antistatic bag:
1. Hold the unit horizontally with the faceplate toward you.
2. Slide the opening of the bag over the connector edge.
If you must insert the line card into a bag by yourself:
1. Lay the unit horizontally on an antistatic mat that is on a flat, stable surface with the sheet-metal side
down.
2. Orient the unit with the faceplate toward you.
3. Carefully insert the connector edge into the opening of the bag and pull the bag toward you to cover
the unit.
Take a PTX10004 Line Card Online or Offline
The offline/online (OFF) button is recessed below the faceplate directly below the status (STS) LED. You
can take any of the PTX10004 line cards online or offline using either of these two methods:
Press the OFF button with a non-conductive pin tool, such as a toothpick, until the STS LED turns off
after about 5 seconds.
Issue the CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot offline
Install a PTX10004 Line Card
Before you install a line card in the router chassis:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage.
See
"Prevention of Electrostatic Discharge Damage" on page
Ensure that you know how to handle and store the line card. See
Line Cards" on page
207.
Inspect the connector edge of the line card for physical damage. Installing a damaged line card might
damage the router.
298.
"How to Handle and Store PTX10004
209
Advertisement
Table of Contents
