Table 36: Physical Specifications for a JNP10K-PWR-AC2 Power Supply
Specification
Height
Width
Depth
Weight
PTX10004 Power Cable Specifications
IN THIS SECTION
JNP10K-PWR-AC2 Power Cable Specifications | 97
JNP10K-PWR-AC2 Power Cable Specifications for 30-A Input | 100
Most sites distribute power through a main conduit that leads to frame-mounted power distribution panels,
one of which can be located at the top of the rack that houses the router. An AC power cord connects
each power supply to the power distribution panel.
NOTE:
In North America, AC power cords must not exceed 15 feet (approximately 4.5 meters)
in length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and
210-52 and Canadian Electrical Code (CEC) Section 4-010(3). The cords shipped with the router
to North America and Canada are in compliance.
The PTX10004 AC, high-voltage alternating current (HVAC), and high-voltage direct current (HVDC) power
supplies have specific cord requirements. Use the following sections to determine the cable requirements
based on the model of your power supply and any mode settings:
For JNP10K-PWR-AC2 with 20-A input, see
For JNP10K-PWR-AC2 with 30-A input, see
Input" on page
100.
Value
3.5 in. (8.89 cm)
3.6 in. (9.14 cm)
15.1 in. (38.35 cm)
11.4 lb (5.17 kg)
"JNP10K-PWR-AC2 Power Cable Specifications" on page
"JNP10K-PWR-AC2 Power Cable Specifications for 30-A
96
97.