Ptx10004 Console And Management Cable Specifications And Pinouts; Console Port Connector Pinouts For A Ptx10004 - Juniper PTX10004 Hardware Manual

13 dBm – 0.5 dBm [HOL] – 5 (0.5 dBm) – 2 (0.5 dBm) – 2 km (1.0 dBm/km) – 1 dB [CRM] = P
13 dBm – 0.5 dBm – 2.5 dBm – 1 dBm – 2 dBm – 1 dBm = P
P = 6 dBm
M
The calculated power margin is greater than zero, indicating that the link has sufficient power for
transmission. Also, the power margin value does not exceed the maximum receiver input power. Refer
to the specifications for your receiver to find the maximum receiver input power.
PTX10004 Console and Management Cable
Specifications and Pinouts
IN THIS SECTION

Console Port Connector Pinouts for a PTX10004 | 110

USB Port Specifications for the PTX10004 | 112
Management Port Connector Pinouts for the PTX10004 | 112
The following sections describe the console port, the USB port, and the management port connections
and specifications for the PTX10004 router.
Console Port Connector Pinouts for a PTX10004
The console port (labeled CON) on the Routing and Control Board (RCB) panel is an RS-232 serial interface
that uses an RJ-45 connector to connect to a console management device. The default baud rate for the
console port is 9600 baud.
Table 43 on page 111 provides the pinout information for the RJ-45 console connector. An RJ-45 cable
and RJ-45 to DB-9 adapter are supplied with the PTX10004 routers.
M
110
M