CAUTION:
has attached an appropriate grounding lug to the grounding cable that you supply.
Using a grounding cable with an incorrectly attached lug can damage the router.
JNP10K-PWR-AC2 Power Supply LEDs
The JNP10K-PWR-AC2 power supply has four LEDs on its faceplate: !, OK, 2, and 1. These LEDs display
information about the status of the power supply. See
Figure 21: LEDs on a JNP10K-PWR-AC2 Power Supply
1
2
1
! Fault
—
2
OK Power OK
—
NOTE:
Physical markings on the power supply are 1 and 2. These markings correspond to INP0
and INP1 in the show chassis power output (see
on page
59).
show chassis power
Before you begin installing the router, ensure that a licensed electrician
3
4
Figure 21 on page
58.
3
2 INP2–Source input 1
—
4
1 INP1–Source input 0
—
Table 16 on page 59
and
"show chassis power"
58