Install And Remove A Front Door With Filter - Juniper PTX10004 Hardware Manual

Install and Remove a Front Door with Filter

The optional JNP10004-FRPNL1 EMI front door has an air filter. We recommend that you replace the air
filter every six months. The order number for a spare filter is JNP10004-FLTR.
Be sure you have the following tools and parts before your begin:
A Phillips(+) screwdriver, number 2 (not provided)
Front door (provided)
Three cable seals—Two seals for the right side and one for the left side (provided)
Cable management system (provided)
See Figure 55 on page 139
Figure 55: JNP10004-FRPNL1 Components
1
1 EMI front door with filter frame
—
2 RCB cable seal
—
To install a front door with an air filter:
1. Install the cable management system.
CAUTION:
system installed to remove or install the line cards if you use the front door with
an air filter.
for the shipped components.
4
See"Install the PTX10004 Cable Management System" on page
You must have the extended ejector handles of the cable management
2
3
3 Right cable seal
—
4 Left cable seal
—
139
215.