How To Hold A Sib - Juniper PTX10004 Hardware Manual

How to Hold a SIB

SIBs are installed vertically and should be held vertically until they are clear of the router before rotating
them 90 degrees and placing them on an antistatic mat or placing them in an antistatic bag for storage.
See Figure 94 on page 197.
Figure 94: JNP10004-SF3 Switch Interface Board
The proper method of holding a SIB is to:
1. Hold the SIB by the ejectors while you keep the SIB vertical, and slide the SIB about three-quarters of
the way out of the chassis.
2. Place one hand underneath the SIB to support it, and slide it completely out of the chassis.
CAUTION:
and the SIB won't align and seat properly if the connector is damaged.
CAUTION:
component.
Never hold the SIB by the connector edge. The connectors are fragile
Don't stack SIBs on top of one another or on top of any other
197