Table of Contents
Advertisement
CHAPTER 15
Connecting CSE2000
Connecting the CSE2000 to the Router
Copyright © 2014, Juniper Networks, Inc.
Connecting the CSE2000 to the Router on page 57
Upgrading the CSE2000 Software Package on page 59
Activating the LOCATOR LED on page 60
Video:
Connecting the CSE2000 to the PTX5000 Router
Before you connect the CSE2000 to a PTX5000 router, ensure that:
The PTX5000 router runs Junos OS Release 13.3 or later.
The PTX5000 router has 10-Gigabit Ethernet SFP+ PICs with 10GBASE-SR or
10GBASE-LR transceivers.
You have fiber-optic cables to connect the CSE2000 to the PTX5000 PICs.
Transceivers (10GBASE-SR or 10GBASE-LR) are installed in 10-Gigabit Ethernet ports
of the CSE2000.
To connect the CSE2000 device to the PTX5000 router:
Plug the appropriate cables to the 10-Gigabit Ethernet ports on CSE2000. Plug the
1.
other end of the cables to the 10-Gigabit Ethernet ports on the PICs installed in the
FPC of the PTX5000. The 10-Gigabit Ethernet ports are used for data traffic.
NOTE:
You can connect the 10-Gigabit Ethernet ports of a service card to
any port in the 10-Gigabit Ethernet SFP+ PICs of the same FPC in
PTX5000, but you cannot connect the data traffic ports of the same
service cards to different FPCs.
Connect the 1-Gigabit Ethernet ports, labeled 0 and 1, on each service card, with RJ-45
2.
cables to the 1-Gigabit Ethernet ports (labeled
boards (
and
) of the PTX5000 router. The 1-Gigabit Ethernet ports are used
CB0
CB1
for control traffic. The 1-Gigabit Ethernet ports are connected in the following way:
(X)GE 0
to
(X)GE 3)
on the control
57
Advertisement
Table of Contents
