Table of Contents
Advertisement
USB Port Specifications for the PTX10004
The following Juniper Networks USB flash drives have been tested and are officially supported for the
USB port in the PTX10004 routers:
RE-USB-1G-S—1-gigabyte (GB) USB flash drive
RE-USB-2G-S—2-GB USB flash drive
RE-USB-4G-S—4-GB USB flash drive
CAUTION:
routers has not been tested by Juniper Networks. The use of any unsupported USB
memory product could expose your device to unpredictable behavior. Juniper Networks
Technical Assistance Center (JTAC) can provide only limited support for issues related
to unsupported hardware. We strongly recommend that you use only supported USB
flash drives.
CAUTION:
PTX10004 routers. Failure to do so could expose your device to unpredictable behavior.
NOTE:
USB flash drives used with the PTX10004 router must support USB 2.0 or later.
Management Port Connector Pinouts for the PTX10004
The 1000BASE-T RJ-45 management ports use an RJ-45 connector to connect a management device for
out-of-band management.
Table 44 on page 113
provides the pinout information of the RJ-45 management port connector. An RJ-45
cable is supplied with the PTX10004 router.
Any USB memory product not listed as supported for the PTX10004
Remove the USB flash drive before upgrading Junos OS or rebooting
112
Advertisement
Table of Contents
