Remove A Ptx10004 From A Four-Post Rack Using A Mechanical Lift - Juniper PTX10004 Hardware Manual

LED panel on the front of the router chassis, and the other ESD point is located in the rear below the
power supplies.
4. Disconnect power to the router by performing one of the following tasks:
AC power supply—Set the enable router switch to the off (O) position and gently pull out the coupler
for the power cord from the faceplate.
DC power supply—Switch the circuit breaker on the panel board that services the DC circuit to the
off position.
5. Remove the power source cable from the power supply faceplate:
AC power supply—Remove the power cord from the power supply faceplate by detaching the power
cord retainer and gently pulling out the power cord plug that is connected to the power supply
faceplate.
DC power supply—Loosen the thumbscrews by securing the DC power connector on the power
source cables. Remove the power source cables from the power supply.
6. Remove any remaining cables and optics before you remove the chassis from the rack.
SEE ALSO
Remove a JNP10K-PWR-AC2 Power Supply | 181
Remove a JNP10K-PWR-DC2 Power Supply | 192

Remove a PTX10004 from a Four-Post Rack Using a Mechanical Lift

Because of the router's size and weight, we strongly recommend that you use a mechanical lift to install
the PTX10004.
NOTE: For instructions on installing a router without using a mechanical lift, see
Remove a PTX10004 from a Four-Post Rack" on page
Before you remove the router using a lift:
235.
233
"Manually