Install The Ssr1300 In A Rack; Connect Your Ssr1300 To The Mist Cloud - Juniper Cloud-Ready SSR1300 Quick Start Manual

Install the SSR1300 in a Rack

Install the SSR1300 in a rack and connect it to power. For instructions see the hardware guide on the
Supported Hardware page.

Connect Your SSR1300 to the Mist Cloud

Your SSR1300, uses port labelled MGMT (mgmt-0/0/0) as the default port to contact Mist for zero-touch provisioning
(ZTP). It uses port 0/3 (xe-0/0/3) to connect to the LAN.
1. Connect the MGMT port to an Ethernet link that can assign a DHCP address to the SSR1300 and provide
connectivity to the Internet and Mist.
NOTE: For management, you can connect the SSR1300 to Mist using the MGMT port. You can also connect
to Mist from one of the WAN ports only when the MGMT port is disconnected, or does not have a valid
DHCP leased address and default route.
Do not change the Mist management port once your appliance is powered on and connected to the Mist
Cloud instance.
2. Connect port 0/3 to your LAN devices, such as
• Mist-managed Juniper EX switches
• Mist APs
• User devices
3. Power on the SSR1300.
Great job! Your SSR1300 is now connected to the Mist cloud! In just a few minutes, Mist will send the template-driven
configuration down to your device. Once the configuration has been applied, it will begin forwarding sessions from LAN
to WAN as described by your policy.
Go to the WAN Edges menu on the Mist sidebar, select your device, and watch events as the device completes ZTP.
7
Juniper Mist