Front Panel; System Status Leds - Juniper SSG 5 Serial Hardware Installation

SSG 5 Hardware Installation and Configuration Guide
Port Description
ISDN Enables the ISDN line to be used as the untrust or
backup interface. (S/T)
Antenna A & B Enables a direct connection to workstations in the
(SSG 5-WLAN) vicinity of a wireless radio connection.

Front Panel

System Status LEDs

10
Front Panel
This section describes the following elements on the front panel of an SSG 5 device:
System Status LEDs
Port Descriptions
The system status LEDs display information about critical device functions. Figure 3
illustrates the position of each status LED on the front of the SSG 5 V.92-WLAN
device. The system LEDs differ depending on the version of the SSG 5 device.
Figure 3: Status LEDs
When the system powers up, the POWER LED changes from off to blinking green,
and the STATUS LED changes in the following sequence: red, green, blinking green.
Startup takes approximately two minutes to complete. If you want to turn the
system off and on again, we recommend you wait a few seconds between shutting
it down and powering it back up. Table 2 provides the type, name, color, status, and
description of each system status LED.
Connector Speed/Protocol
RJ-45 B-channels at 64 Kbps
Leased line at 128 Kbps
RPSMA 802.11a (54 Mbps on 5GHz radio band)
802.11b (11 Mbps on 2.4 GHz radio band)
802.11g (54 Mbps on 2.4 GHz radio band)
802.11 superG (108 Mbps on 2.4 GHz and
5GHz radio bands)