IACDRIVE I5000 Series Operation Manual page 83

Notice: During auto current limiting process, the inverter's output frequency may
change; therefore, it is recommended not to enable the function when output
frequency need to be stable.
Function Code
Pd.10
1: The fan operates automatically
Function Code
Pd.11
Function Code
Pd.12
0: The fan operates for long time
When inverter is in PID control mode, output frequency is less than the value set by Pd.11,
and after the sleep detection time set by Pd.12, inverter stop outputting, and SLEEP is
flashing, it is mainly used in closed-loop control.
Function Code
Pd.13
Function Code
Pd.14
When invert setting is positive, feedback pressure is less than the value of wake pressure,
and after the wake delay time set by Pd.14, inverter removes sleep status, and continue
outputting frequency.
When invert setting is negative, feedback pressure is lager than the value of wake
pressure, and after the wake delay time set by Pd.14, inverter removes sleep status, and
continue outputting frequency.
6.15 PE Group—Factory Setting
This group is the factory-set parameter group. The user DO NOT try to open these group
parameters, otherwise it will cause the inverter abnormal operation or damage.
Name
Fan operation selection
Name
Sleep frequency
Name
Sleep detection time
Name
Wake pressure
Name
Wake delay time
Setting Range
Setting Range
0.0~1000S [0.0S ]
81
Setting Range
0~1 [1 ]
0~50 [0 ]
Setting Range
0~10V [0V ]
Setting Range
0.0~1000 [0.0 ]