Running State - IACDRIVE I5000 Series Operation Manual

If "Sensorless Vector Control" mode is chosen, motor nameplate parameters must be input
correctly as the auto-tuning is based on it. The performance of vector control depends on the
parameters of motor strongly, so to achieve excellent performance, firstly must obtain the
parameter of motor exactly.
The procedure of motor parameter auto-tuning is as follows:
Firstly, choose the keypad command channel as the operation command channel (P0.01).
And then input following parameters according to the actual motor parameters: P2.00:
motor rated power.
P2.01: motor rated frequency; P2.02:
motor rated speed; P2.03: motor rated
voltage; P2.04: motor rated current
Notice: the motor should be uncoupled with its load; otherwise, the motor parameters
obtained by auto-tuning may be not correct.
Set P0.12 to be 1, and for the detail process of motor parameter auto-tuning, please refer to the
description of Function Code P0.12. And then press RUN on the keypad panel, the inverter will
automatically calculate following parameter of the motor:
P2.05: motor stator resistance; P2.06:
motor rotor resistance;
P2.07: motor stator and rotor inductance; P2.08: motor
stator and rotor mutual inductance; P2.09: motor current
without load;
then motor auto tuning is finished.
5.2.4 Password setting
I5000 series inverter offers user's password protection function. When P7.00 is set to be nonzero,
it will be the user's password, after exiting function code edit mode, it will become effective after 1
minute. If pressing the PRG/ESC again to try to access the function code edit mode,
"0.0.0.0.0"will be displayed, and the operator must input correct user's password, otherwise will
be unable to access it.
If it is necessary to cancel the password protection function, just set P7.00 to be zero.

5.3 Running State

5.3.1 Power-on initialization
Firstly the system initializes during the inverter power-on, and LED displays "-I5000-". After the
30