IACDRIVE I5000 Series Operation Manual page 67

Auto reset function can reset the fault in preset times and interval. When P8.11 is set to be 0, it
means "auto reset" is disabled and the protective device will be activated in case of fault.
Notice: The fault such as OUT 1, OUT 2, OUT 3, OH1 and OH2 cannot be reset
automatically.
Function
Code
P8.13
P8.14
when the output frequency reaI5000s a certain preset frequency (FDT level), output
terminal will output an ON-OFF signal until output frequency drops below a certain
frequency of FDT level (FDT level - FDT lag), as shown in following figure.
Name
FDT level
FDT lag
Figure 6.18 FDT level and lag diagram.
Description
0.00~ P0.04 0.00~ P0.04
0.0~100.0%
65
Setting Factory
Range Setting
50.00Hz
0.0~100.0 5.0%