Table of Contents
Advertisement
0: Keypad (LED extinguished);
Both RUN and STOP/RST key are used for running command control. If Multifunction key
QUICK/JOG is set as FWD/REV switching function (P7.03 is set to be 1), it will be used to
change the rotating orientation. In running status, press
STOP/RST in the same time will cause the inverter coast to stop.
1: Terminal (LED flickering)
The operation, including forward run, reverse run, forward jog, reverse jog etc. can be controlled
by multifunctional input terminals.
2: Communication (LED lights on)
The operation of inverter can be controlled by the host through communication.
Function
Code
UP/DOWN
P0.02
0: User can adjust the reference frequency by UP/DOWN. The value of UP/DOWN can be
saved when power off.
1: User can adjust the reference frequency by UP/DOWN, but the value of UP/DOWN will not
be saved when power off.
2: User can not adjust the reference frequency by UP/DOWN. The value of UP/DOWN will be
cleared if P3.05 is set to 2.
3: User can only adjust the reference frequency by UP/DOWN during the inverter is running.
The value of UP/DOWN will be cleared when the inverter stops.
Notice:
UP/DOWN function can be achieved by keypad
multifunctional terminals.
Reference frequency can be adjusted by UP/DOWN.
UP/DOWN has highest priority which means UP/DOWN is always active no matter which
frequency command source is.
When the factory setting is restored (P1.03 is set to be 1), the value of UP/DOWN will be
cleared
Name
0: Valid, save
value when power off
1:
Valid,
UP/DOWN
setting
power off
2: Invalid
3: Valid during running, clear
when stop.
Description
UP/DOWN
do
not
save
value
when
∧and∨
34
RUN
and
Setting
Factory
Range
Setting
0~3
0
Advertisement
Table of Contents
