IACDRIVE I5000 Series Operation Manual page 54

Notice: When 2-wire control mode is active, the inverter will not run in following situation
even if FWD/REV terminal is enabled:
Coast to stop (press RUN and STOP/RST at the same time)
Stop command from serial communication.
FWD/REV terminal is enabled before power on.
Function Code
P5.08
Terminal UP/DOWN regulates the incremental rate of setting frequency
Function Code
P5.09
P5.10
P5.11
Figure 6-11 3-wire control mode 2
Name
UP/DOWN setting change
rate
Name
FV lower limit
FV lower limit
corresponding setting
FV upper limit
52
Setting Range
0.01~50.00[0.50 Hz/s]
Setting Range
0.00~10.00[0.00V]
-100.0~100.0
[0.0%]
0.00~10.00[10.00V]