Arrow AutoCAT 2 Series Operating Manual page 36

Around the LCD is the control function keypad. These control keys allow you to select
all operating functions needed to run the AutoCAT
labeled individually with their corresponding function. Similar functions are grouped
together. In addition, the power switch is located on the front of the console (shown in
Figure 3.4). The operating functions of the displays and control keys are explained in
detail in Section 3.3. The control keys are grouped into the following categories:
• ECG Source Select - ECG Skin /Monitor
• AP Source Select - Fiber Optic (FiberOptix
• Operations Mode: AutoPilot
• Inflate/Deflate Timing Controls
• Pump Status
• Alarms Reset and ON/OFF
• Recorder
• Freeze Display
• Balloon Volume
• Assist Ratios
• Help
• Home
• Trigger
• Arrhythmia Timing
• Multi-Function Keys
Seven additional multi-function keys are located under the LCD display and correspond
to the operation indicated directly above the key on the LCD.
The multi-function key legends change in response to certain operating key presses.
These include:
• ECG Source select (ECG Lead Select and gain control)
• AP Source Select (Zero/Calibration/AP Scale/AP Alarm/Autoscaling ON or OFF)
• Alarms OFF (select time for alarms to be disabled)
• Balloon Volume (Volume Controls)
• Trigger Mode (Seven trigger modes) Operator mode only.
• HOME (additional operating controls)
These keys will automatically return to the normal functions after 30 seconds, or
immediately when the HOME key is pressed. The currently selected function is
highlighted in reverse video.
3 . 1 : O v e r v i e w o f t h e A u t o C A T
® 2 Series. The control keys are
sensor)/Transducer /Monitor
™
or Operator
™
AutoCAT
3 . P r i n c i p l e s o f O p e r a t i o n
® 2 S e r i e s
® 2 Series Display and Function Keys
3-9